升降货梯http://www.jntr168.com/安装储罐的基础要求平整，并能承受相应的压力。储罐安装设备在出厂时已安装好了接头，强度是最佳的。但在运输、装卸时接头可能会引起松动，宜在安装时对接头密封性能进行检查。
Cargo lifter installed base of the tank should be smooth, and can withstand the corresponding pressure. Tank install equipment at the factory installed the joint strength is the best. But in the transport, handling may cause loose

joints, should be in the installation of the Joints to be checked.
　 
在升降货梯先期施工的罐底板上安装数个固定垫墩，然后组装第一层壁板和顶盖板，沿罐内壁400mm处均布数台液压提升机，以提升机的滑动托架托住固定在罐内壁的胀圈下部，操纵液压提升机的控制距。
Pre-installed on a cargo lifter construction of the tank floor mat several fixed pier, then assembled the first layer of wall and roof panels, along the tank wall at a uniform number of 400mm hydraulic hoist to lift up the machine to enhance the sliding bracket fixed in the lower part of the tank wall expansion ring, hydraulic steering control from the hoist.

 升降货梯http://www.jntr168.com/在使用过程中需要检查安装盲板，盲板要安装在最靠近储罐的法兰处。盲板要安装在截止阀最适合进行试压的一侧，盲板两侧应安装密封垫圈，按照需要至少在盲板的受压一侧要加密封垫圈。工作人员能否到达所选择的 储罐安装设备盲板安装位置，是否制定了消除或减少跑冒滴漏、防止污染的有关规定。盲板是否安装在最靠近设备、储罐或容器的法兰处。对升降货梯储罐检修时，如需现场射线探伤时，应隔离出透照区，设置安全标志。
Cargo lifter in the course you need to check the installation Blind, blind flange to be installed closest to the tank. Blind side of the shut-off valve must be installed in the most suitable for the pressure test, should be installed on both sides of the blind plate gasket, according to at least one side of the blind in the pressure plate to add gasket. Staff can reach the selected tank installations Blind installation location, whether formulated to eliminate or reduce leaking, to prevent contamination of the relevant provisions. Blind flange plate is installed in the closest device, tank or vessel. When cargo lifter tank for maintenance, while for site-ray detection, should isolate the transillumination area, set up safety signs.