升降货梯http://www.jntr168.com/在使用之前，一定要按照使用要求来进行调试，才能够保证在生产的过程中，能够安全的生产，给操作人带来安全。那么新买来的升降货梯如何进行调试呢？

1、对于升降货梯来说，是要调整防坠安全器制动的距离，按照GB/T10054-19的规定，它的坠安全器的制动距离应在0.25~1.2m。并不是制动距离越短就越好。相反，制动距离越短，所产生的冲击力就越大，对机构造成的破坏就越大，特别是高速升降机，其危害尤为严重。
For cargo lifter, is to adjust the anti-fall safety braking distance, in accordance with the provisions of GB / T10054-19, the braking distance of its fall safety device should be 0.25 ~ 1.2m. The shorter, the better is not the braking distance. On the contrary, the braking distance is shorter, the impact force generated by the greater damage to the body caused by the greater, especially in high-speed lift, which is particularly serious harm.

2、升降货梯需要调试压轮及滚轮，安装前先将吊笼和驱动机构的全部偏心滚轮轴松开或将偏心距调至最大，分别将吊笼和驱动机构安装于导轨架中，并将两者连接。通电驱动吊笼上升离地面lm或脱离地面缓冲弹簧为止。
Cargo lifter need to debug pressure wheel and the wheel, install all the eccentric roller shaft hoists and before the first release of the drive mechanism or the eccentricity to the maximum, respectively, hoists and drive mechanism mounted on the frame rails, and the two connection. Powered drive cage lm rise from the ground or from the ground up buffer spring.

3、升降货梯http://www.jntr168.com/需要调试制动器，制动力矩越大制动时的冲击就越大，制动力矩过小时，会造成吊笼下溜或撞击事故。对于有多个制动单元的驱动机构，其每个制动器之间的制动力矩的误差应≤10nm，否则会造成个别制动块(盘)烧损。
Cargo lifter need to debug brake, brake torque the greater the impact on the greater braking, the braking torque is too small, will cause the next cage slip accident or collision. For multiple braking unit drive mechanism, each brake braking torque between the error should ≤10nm, otherwise it will create individual brake pads (disc) burning.