升降机在建筑行业的应用越来越广泛,升降机在使用过程中,电气具有重要的影响,在使用之前升降机厂家需要对机器进行一定的检查。
1、需要用接地电阻测试仪测量升降机钢结构及电器设备金属外壳的接地电阻,不得大于4Ω;
Lift manufacturers need to measure ground resistance tester ground resistance of steel and electrical equipment lifts the metal shell, no larger than 4Ω;
2、需要用500V兆欧表测电动机及电器元件的对地电阻应不小于1MΩ;
Lift manufacturers need to use 500V megger test motor and electrical components to ground resistance shall be not less than 1MΩ;
3、需要检查升降机各安装控制开关,分别打开吊笼笼上各个门,触动断绳保护开关,上下限位开关、极限开关等均应能够起作用;
Lifts lift manufacturers need to check each installation control switch, respectively, on each cage open cage door, touched off the rope protection switch, upper and lower limit switches, limit switches, etc. should be able to work;
4、需要校核电动机界限,吊笼上、下运动方向应与操作盒所示方向一致。
Lift manufacturers need to check the motor boundaries, hanging on the cage, under the direction of movement should be consistent with the operation of the cartridge in the direction shown.
请长按保存二维码后点击确定按钮,进入微信扫一扫界面,点击右上角‘相册’选择我们的二维码,再点击右上角‘完成’识别添加。
(为防止浏览器错误识别,请勿直接在浏览器中识别二维码)